Following from last week’s postÂ ?we will share some information on working with red gold alloys, particularly tips around melting, cooling, and fabricating.
Common practice for red alloys after heating/annealing is to allow the metal to come off red before quenching.
Because of the quantities of Copper necessary for the colour of these alloys upon casting a large grain structure can occur. This can result in grain boundary separation/cracking.
Ways around this if applicable are pouring a smaller ingot or annealing the metal prior to working.
Some reds require air cooling after casting whereas others can be quenched once the red glow has dissipated or they can be immediately quenched into hot water.
Once an alloy has been worked down and annealed/heat treated then its structure can balance out to a more user friendly condition. This is the stage our customers would receive the metal.
So at this stage as an alternative to air cooling quenching in hot water can be beneficial as the element of shock is reduced.
Quenching into water that contains a small amount of alcohol i.e. 5% of methylated spirits or Isopropyl alcohol will help with surface oxidation.
All alloys behave differently.
Methodical testing will give definitive results. i.e. Air cooling/quenching but this is not always possible for a Jeweller who has limited product.
Breakdown should be restricted to 50% or twice the original length after elongation although some alloys respond better to higher percentages. Too little work and frequent annealing can have adverse effects.
Our general fabrication annealing temp. is 650Ëšc or by hand torch/eye a dull red. A controlled atmosphere always produces better results when annealing red alloys.
Here are links to websites where you can learn about soldering based onÂ ?extensive testing on a range of different solders and alloys: